“Put it in the middle” leaves a lot of room for interpretation. A design can be centered on the fabric and still look wrong when someone wears the shirt.
Choose the size and placement on the actual garment style before you order every transfer.
Measure the garment you will decorate
Lay the shirt flat without stretching it. Smooth the body and check the available area between seams, neckline, pockets, and other obstructions. Garments with the same size label can have different proportions.
Separate the visual placement decision from the pressing setup. A hoodie's pocket or seam may look far enough away but still interfere with flat platen contact.

Make a full-size paper mockup
Print the design outline on paper at 100% scale. Disable any fit-to-page option and verify the result with a ruler. For a large design, tile several pages and tape them together.
Set the mockup on the garment. Check its distance from the neckline and its relationship to the usable chest area. Look at both the artwork's outer box and its visual weight: a large flourish or uneven logo shape can make a mathematically centered design appear off-center.
A design can be centered on the fabric and still look wrong when someone wears the shirt.
Check the smallest and largest garments
A single transfer size can work across some size ranges, but it should be a deliberate choice. Test the smallest shirt in the order before deciding that every adult, youth, and toddler garment can share one print size.
For a demonstration, an 11-inch-wide design on a shirt with 18 inches of measured body width leaves seven inches of total width outside the print, or 3.5 inches per side when centered. On a 14-inch-wide body, the same design leaves only 1.5 inches per side. Those are geometry examples, not placement standards or approved printable areas.
Record placement with two measurements
Record the design's width and height, the horizontal reference you used, and the distance from a defined neckline point to the top of the visible artwork. Include the garment style and size.
A photo with a ruler helps explain the measurements. A customer mockup should state the actual print dimensions; a screen image by itself does not establish scale.
Make the approval useful at the press
Once the sample is approved, keep it nearby as a reference. Check the first shirt of each garment size and recheck placement during production. Do not silently shrink an approved design to make a sheet layout work.
- Confirm the garment style and size range.
- Measure the visible art, not empty file margins.
- Check neckline clearance and nearby seams.
- Approve a full-size mockup or physical sample.
- Record the final dimensions and reference points.
See the DTF25 sizing guide for help planning your order. Ask the shop about unusual placements before ordering a full run.
Lead image: AI editorial illustration created for DTF25. Supporting graphic: original DTF25 diagram.